Mustang EcoBoost High Performance Package To Take On Camaro 1LE | Hex Lag Screws Factory

Losing a wheel is no joke and I’ve unfortunately had it happen a few times, though in much harsher environments. I had wheel stud failure in an E36 328is I was racing in American Endurance Racing at Mid-Ohio last October. It did not end well.

That’s not the only reason the car leaves hard and straight with both front wheels off the ground. There’s also a custom anti-roll bar out the back fabricated by Mike Crossing at Race On Customs, as well as Competition Engineering shocks front and rear. There are also tubular arms on the front by James Cloke and CRS tubular control arms out back.

Mumbai Indians (Playing XI): Quinton de Kock(c), Evin Lewis, Rohit Sharma(w), Suryakumar Yadav, Hardik Pandya, Kieron Pollard, Krunal Pandya, Anukul Roy, Rahul Chahar, Lasith Malinga, Jasprit Bumrah

Crawford said contaminants should be cleaned from the upper plate with a scraper to view the plate for damage. Lubrication and inspection are critical for long life of these components, she said.

Newsnifty is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com.

The reverse-cowl scoop hides all the spinning parts of the blower set-up, but those Quick Fuel 950 carbs sit up high and mighty

CCJ Magazine covers fleet management topics ranging from technology, freight, logistics, equipment, and more.

Before you handle the task of body panel adjustment, overall body dimensions need to be checked. How true is the body you’re about to assemble? Has it ever been wrecked and if so was the repair up to par dimensionally? Was the body treated to a frame table where it could be pulled back to factory specifications? These dimensions, which are in any Chevrolet service manual, can be checked before you start adjusting panels.

A floor jack is used here to raise and lower the door as adjustments are being made. Ideally, you will position the jack mid-door to get it centered then make finite adjustments. Snug the bolts to where you can finesse the door yet maintain position then tighten the bolts.

quite helpful.  I needed this graphic to explain to someone the differences between different set screws.  HIT THE SPOT!

As exploration and production move into deeper water, subsea equipment be-comes increasingly more difficult to retrieve and reposition.

Seven airbags and a full suite of driver safety aids including AEB, adaptive cruise control and auto high beams give the Eclipse Cross a top five-star score from ANCAP.